How to use the pine wardrobe on the wood wax oil fir wardrobe wood wax oil step

[ Chinese wardrobe net ] Common wardrobe panels are pine, maple, oak, ash, cherry wood and many other types, fir wardrobe is one of them. In the modern design, more and more people will start to give the wood wax oil to the fir closet, not only because the color of the wood wax oil can be changed, but also environmentally friendly. So how do the pine closet get on the wood wax?

[Notes on wood wax oil on fir closet]

1. It is not too fine to polish before oiling. 180~240 mesh sandpaper is enough. The glue and dust on the fir wardrobe must be removed.

2. Do not use too much oil at one time. When using a brush, remove the oil on the fir wardrobe panel with cotton cloth for 5 minutes after brushing. (When the cotton cloth is oiled, fold it well, so there will be no cloth marks).

3, when the construction of a large area, the brush is more efficient, you can first evenly brush the horizontal stripes, and then follow the lines of the brush. This will color the pinhole portion of the wood texture more evenly.

4. After the first pass, go through the second time.

5, you can use a polishing pad to slightly throw the surface, and then go up the second time.

a, because the dust in the construction environment will stick to the surface.

b. The texture of the wood after casting is more natural.

6. After the last time the oil is dry, you can use a 1500 mesh to 2000 mesh sandpaper to gently wipe the surface to get a very, very good feel.

7. After smearing with 1500 mesh to 2000 mesh sandpaper, it is recommended to use a cotton cloth to smear some oil (Note: cotton cloth is not wet, a little tide will do), wipe the furniture evenly (not too light), just like to make furniture hygienic Or waxing the same.

8, it is recommended to add thinner brush. The addition ratio is 4:1 to 3:1, for example (transparent color wax 4: thinner 1).

[Steps of wood wax oil on fir closet]

1. Polishing.

The fir in the cabinet was directly ground with 240 mesh, 400 mesh, and 600 mesh sandpaper. Note that when grinding with 240 mesh sandpaper, it can be sanded from the direction of the vertical wood grain, and then polished along the wood grain, so that the burrs on the fir can be removed faster. 400 mesh, 600 mesh sandpaper was polished.

Grinding with a sander can greatly improve the construction efficiency. Personally, if it is a DIY TX, be sure to buy a sander. The price of more than one hundred yuan will definitely make you spend money without regretting it.